Afterwards, make use of the following command to connect the AP to the Unifi Controller.Use the following credentials to log in.Connect to the access point by typing the IP address into putty and selecting SSH (Port 22).Start putty (you can download it from ).Look for the IP address of your access point (identify it by looking for the MAC address in the DHCP server or use an IP scanner).Reset the access point if you used it before.To get an access point connected to the Ubiquiti Unifi Controller, go through the steps of the following instruction: Instruction But let’s not beat around the bush any longer and get back to our problem at hand. If you want to take a look on some available commands, check out this Github page. There’s actually quite some stuff you can do with your Ubiquiti Unifi access points when connecting via SSH, like for example resetting them entirely (which you should do anyway before going through the instructions). I’m talking about using the command line. However, there are ways to still get it done, even though we have to take an old-fashioned (or you may call it nerdier) approach. Well, things quickly become more complicated than clicking a fancy button on a shiny web interface. But this raises the question of what happens when we seperate the Controller and the access points into different networks, be it by VLAN or physical segregation. In its default configuration, the Ubiquiti Unifi Controller is automatically looking for new access points within its own network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |